Trafficmaster Vinyl Plank Flooring Installation Instructions

When securing two planks together you should angle 45 degrees the second plank into the corresponding edge.

Trafficmaster vinyl plank flooring installation instructions. This will allow for subfloor contraction and expansion. Connect the flooring planks. Trafficmaster allure floating vinyl plank flooring can be a great vinyl floor product for bathroom or kitchen flooring when it is installed properly. This will allow the floor to expand with environmental changes link the boards at their ends cutting the last one to fit against the perpendicular wall.

See my flooring install playlist. Place the second plank at the 45 degree angle with the overedge on top of the underedge. The over edge always placed on top of the under edge. Starting at one end of the plank use one hand to hold the plank and the other hand to roll the edge into place for a tight fit.

Lay the first plank appropriately spaced from the wall. Allure plank and tile installation instructions 3. Install the second plank by holding it at an angle and inserting its tongue edge into the first plank s groove edge. 7installing click lock vinyl plank flooring.

The trick is to start attaching them at a 45 degree angle in the top corner and work your way down and then along the plank applying ample pressure during this process. How to install vinyl plank flooring as a beginner. Leave a half an inch of space at the wall. Unlike self stick vinyl or glue down vinyl tiles both of which are installed with a full glue down application under the entire tile plank vinyl flooring is adhered only at the edges floating over the subfloor.

Lay the first course of traffic master floorboards along one wall so the grooved sides of the floorboards face the wall. The installation of trafficmaster vinyl plank flooring requires acclimation for at least 48 hours in the room of installation. The room of installation must be between 65 f 85 f 10 c 38 c before during and after installation. As this is a floating floor adhesive gripstripstm help to easily secure the planks to each other.

Trim the short tongue edge from the first vinyl plank. One plank lies flat on the subfloor while the other plank is held at an angle and placed into the first board s receiving groove.