Tools To Make Lock Holes In The Door And Jam

How to fill holes left when a door strike was moved.

Tools to make lock holes in the door and jam. The bolt will make a pencil mark on the doorjamb. The lock cylinder leaves a hole over 2 inches in diameter completely through the door and there s an additional hole through the door edge where the bolt used to reside. Align the edge of the strike plate s hole just to the door side of the mark and proceed with scoring around the strike plate. This project guide features step by step instructions to tackle after you have already drilled holes in the door.

The strike will hold the bolt in place keeping the door locked until the bolt is retracted using a key or thumb turn. Hang the door in the jamb. You can also refer to the manufacturer s instructions that were included with the door latch or deadbolt you are. Turn the knob and hold it to keep the bolt retracted.

Place the door in the jamb and fasten it to the hinges. You ll need to cut a mortise a small shallow recess in the wood of the door and doorjamb for the latchbolt and strike plate to rest. Bi metal hole saw d180016. Unless you are installing a prehung door you ll need to trace the outline of the hinges on the jamb and cut an indentation using a router or utility knife.

Close the door tightly and let go of the knob. Use a rotary tool to help you make a perfect mortise for the faceplate of a door latch when installing door hardware. Fortunately cutting out this mortise isn t nearly as difficult as it sounds. The strike is installed on the door frame and contains a hole that catches the latch or bolt that extends from the lock.

Dewalt d180004 door lock installation hole saw kit. For every doorknob or deadbolt lock installed in your home a hole was drilled in the door jamb and covered with a perforated strike plate. Knowing how to cut a mortise is essential for installing a deadbolt lock. If you want your door lockset to operate smoothly and not bind up when you turn the doorknob or try to lock it it s imperative the two holes you drill align perfectly in both directions.

To allow proper clearance for the lock to operate most strike plates are recessed into the door frame. Screw the hinges onto the correct side of the jamb. Door lock installation kit d180004.